10:39:58.886: >> 535 5.7.0 ...authentication rejected
This log entry indicates that the login credentials are not what Spectrum expects so the message should not be getting sent. I suggest that after you change your password that you re-enter the username and password information in the SMTP host configuration.
Tools > Internet options > Sending (SMTP) tab
Select the host file listed then click the Edit button
You will also need to enter the new password in the POP3 host file located in the Receiving(POP3) tab.
[2] Also on another matter I was asked if my renderer had latest version.....where do i go to check this?
To see the installed version number hover over the IERenderer icon located furthest right in the toolbar of the Pegasus Mail main window. The current version is 2.7.1.5.
[3] also I still want to raise my default print when reading and/or composing messages as my sight not that great and everything is so small to read.....never seemed that way before.
You can specify the font to be used.
If you use Preview mode click the Font button (blue lowercase "f" ) in the main toolbar to access a configuration screen where you can specify the font for each pane.
When working in Pegasus Mail windows, the font for the active window can be set by using the same Font button so you would do it for the reader window, then for the composition window, and also for folder windows. This works for all Pegasus Mail child windows. It does not work for Help or for any configuration window. Note: There is a way to set a default for folder windows. That should be a separate discussion though.
Finally, you can not control the font used in the HTML content of messages but the IERenderer configuration options contains a zoom factor setting the may be valuable. To access that, click on the IERenderer toolbar button and select "Configure IERenderer". If is is greyed out, click on a message that contains HTML content then try again.
[quote="pid:56291, uid:30801"]10:39:58.886: >> 535 5.7.0 ...authentication rejected[/quote]
This log entry indicates that the login credentials are not what Spectrum expects so the message should not be getting sent. I suggest that after you change your password that you re-enter the username and password information in the SMTP host configuration.
Tools > Internet options > Sending (SMTP) tab
Select the host file listed then click the Edit button
You will also need to enter the new password in the POP3 host file located in the Receiving(POP3) tab.
[quote="pid:56291, uid:30801"][2] Also on another matter I was asked if my renderer had latest version.....where do i go to check this?[/quote]
To see the installed version number hover over the IERenderer icon located furthest right in the toolbar of the Pegasus Mail main window. The current version is 2.7.1.5.
[quote="pid:56291, uid:30801"][3] also I still want to raise my default print when reading and/or composing messages as my sight not that great and everything is so small to read.....never seemed that way before.[/quote]
You can specify the font to be used.
If you use Preview mode click the Font button (blue lowercase "f" ) in the main toolbar to access a configuration screen where you can specify the font for each pane.
When working in Pegasus Mail windows, the font for the active window can be set by using the same Font button so you would do it for the reader window, then for the composition window, and also for folder windows. This works for all Pegasus Mail child windows. It does not work for Help or for any configuration window. Note: There is a way to set a default for folder windows. That should be a separate discussion though.
Finally, you can not control the font used in the HTML content of messages but the IERenderer configuration options contains a zoom factor setting the may be valuable. To access that, click on the IERenderer toolbar button and select "Configure IERenderer". If is is greyed out, click on a message that contains HTML content then try again.
